Tools And Accessories; Safety Cut-Out; Maintenance - Filters - Morphy Richards Perfom air VC71067MUK Instruction Book

VC71067MUK Rev5_Instruction Book 19/09/2012 13:40 Page 6
Standard accessories
27
25
24
23
24
23

Tools and accessories

Combination floor nozzle
This nozzle is suitable for general purpose
cleaning on a wide variety of floor coverings.
Turbo nozzle
(28) (certain models only)
This nozzle is suitable for cleaning and
rejuvenating cut pile carpets and is ideal for
picking up stubborn dirt and pet and human hairs.
Cleaning the turbo nozzle
(certain models only)
The turbo nozzle (28)
and any hairs or fibres wrapped around the brush
bar removed to maintain optimum performance.
Upholstery nozzle
This nozzle is ideal for textiles, carpet, upholstery
and stairs etc.
Dusting brush
(26)
This tool is ideal for vacuuming pelmets and
delicate objects and surfaces. This attachment
clips on to the upholstery nozzle (25).
Crevice tool
(27)
This tool is ideal for awkward places, corners, and
behind radiators etc.
Storage
When finished cleaning, switch off the appliance
and remove the plug from the mains supply. Press
and hold the automatic cable rewind button
the power cord (11)
NOTE: Always store the vacuum cleaner base down.
6
24
25
26
28
(23)
should be regularly cleaned
(25)
(8) until
retracts fully into the machine.
Application
Textiles and upholstery
Shelves and hard surfaces
Carpets and other textile
floor coverings (brushes up
on combination floor nozzle)
Settings for heavy dirt and
smooth floors (brushes down
on combination floor nozzle)

Safety cut-out

If the cleaner overheats, a motor protection
thermostat will automatically switch the motor
off. If this happens, switch the cleaner off,
unplug from the power supply and leave the
cleaner to cool for at least 60 minutes. Check
the airways for blockages, empty the dust
canister and clean the filters before restarting.

Maintenance - Filters

The guarantee may be invalidated if the motor is
damaged due to: using the appliance without
the filters installed; not cleaning the filters; or
not replacing damaged filters.
Cleaning the dust canister filter
To maintain suction, the dust canister filter must
be cleaned each time the dust canister
emptied.
Follow steps 1-4 of point 7 of 'Operating / Assembly',
1.
page 5.
Access the filter assembly by removing the dust
2.
canister lid (18). Slide the lid release button
down then rotate the lid anti-clockwise.
(19)
(5) is
(21)
21