Table of Contents
Advertisement
73340 Rev 1
4/3/05
Replacing the HEPA
exhaust filter
The HEPA exhaust filter should be
replaced every 6 months.
• Replacement filters can be purchased
from our replacement parts helpline.
1 Remove the front grille F to access the
HEPA filter.
Safety cut-out
If the cleaner overheats a motor
protection thermostat will automatically
switch the motor off. If this happens, switch
the cleaner off, unplug from the power
supply and leave the cleaner to cool for
at least 30 minutes. Check the airways for
blockages, empty dust canister and clean
the filters before restarting.
6
10:29 AM
Page 6
F
F
Changing the belt
If the brush bar stops rotating it is likely
that the drive belt has snapped (usually
because the brush has been stalled). A spare
belt is supplied. Replacement belts can also
be obtained from Morphy Richards.
Removing the floor nozzle
cover
GH
1 Disconnect the cleaner from the mains
supply.
2 Press the handle release pedal and place
the cleaner face down, in the flat position
on a soft surface (eg carpet).
3 Use a cross-head screwdriver to remove
the four screws indicated G.
4 Turn the cleaner over.
5 While pressing the handle release
pedal lift the rear of the top cover,
unhook from the front then completely
remove the cover H.
G
H
Advertisement
Table of Contents
