Advertisement
iC-7 TO THIRD PARTY ECU SETUP
Part No: HT-130049
4 pin Molex Mini-Fit Jr
Your Haltech iC-7 Display Dash is compatible
conector harness.
with a number of third-party ECUs via a Haltech
iC-7 Adapter Harness (sold separately).
Suits: Microtech ECUs.
ECUs currently supported by the iC-7 Dash:
• Link: Atom, Monsoon, Storm, Extreme, Fury,
Thunder, Force GDI, G5.
• MoTeC: M1 series MoTeC hundred series
(M400,600,800 "gold box" ECUs)
• Microtech
• MaxxEcu
Third-Party ECU Setup
1. Connect to the iC-7 with the ICC software.
2. In the "Load Defaults" drop down menu select
your ECU brand and model.
3. A base configuration will be loaded. This default
configuration can now be customised.
NOTE: For extended functionality of the iC-7
Display Dash, iCC firmware 1.7.3 or later is required.
Earlier firmware versions are supported, but some
channels may not display.
More information located in the ICC Help section.
Part No: HT-130047
Circular M12, 5 pin connector
harness.
Suits: Link Storm, Extreme, Fury,
Thunder, Force GDI ECUs using
Part No: HT-130046
front circular CAN connector.
Flying lead harness with pins for AMP
superseal connectors.
Suits: Link Atom, Monsoon,
Motec ECUs using CAN communications
through AMP superseal connector.
Part No: HT-130048
JST 5 pin connector with a flying
lead power connector harness.
Suits: Link G5 Plug-In ECUs.
14
iC-7 WIRING DIAGRAM
15
Advertisement
