Haltech iC-7 Quick Start Manual page 7

12
ECU configuration for Elite Series ECUs
1. Connect to the ECU with the ESP software
(Elite Software Programmer)
28mm 28mm
2. Go into "Main Setup" (press F4)
3. Click "Devices" on the left tab
4. Under Haltech CAN System, enable the
Haltech CAN Supported Dash (see below)
8mm
5. For extended functionality of the iC-7 Display Through Hole
Dash, Elite firmware 2.35 or later is required.
Earlier firmware versions are supported, but
some channels may not display.
CAN Connection: DTM-4 receptacle
Pin Number Connection
1 +12V Supply
2 Battery Ground
3 CAN High
4 CAN Low
CAN Connection: 34 pin Superseal Connector
Pin Number Connection
1 CAN High
2 CAN Low
3 +12V Supply
4 Battery Ground
Connecting iC-7 Display Dash to a Haltech Platinum Series ECU:
You will need to use an 8-pin Tyco to DTM-4 cable to connect all Platinum Series ECUs to
this device. This cable is supplied with the ECU.
If you already have a Platinum Series ECU and are adding the iC-7 display dash to your
system this cable can be purchased separately (HT-130040).
13
Rear View, Wire Side
Rear View, Wire Side