Advertisement
iC-7 MOUNTING OPTIONS
Moulded Panel Mount
HT-060090
Bolts directly to the back of your iC-7
using three mounting screws provided.
10" x 20", can be trimmed to fit a
variety of cluster surrounds.
Universal Mounting Bracket
with Integrated Visor
HT-060071
Bolts directly to the back of your iC-7 using
three mounting screws provided. Includes a
sun visor which reduces glare and protects
the screen.
Universal Mounting
Bracket
HT-060070
Bolts directly to the
back of your iC-7 using
three mounting screws
provided.
Tube Mount
Connects the Universal Mounting
Bracket to a roll cage or steering
column.
HT-060072 suits tube OD 1.25in
6
If you do not have any devices on your
Haltech CAN bus already:
Connect the DTM-4 into the Auxiliary
CAN Bus Port as shown
If you already have devices on your Haltech
CAN bus (eg Haltech wideband, TCA, I/O
expander):
If there is an open port at the end of the
CAN bus (e.g the spare DTM-4 connector
on a Haltech WB1/WB2), connect the
DTM-4 to the new device into this port
as shown
Otherwise, you will need to add a CAN Hub
(HT-159000).
The Elite CAN Hub features four DTM4
ports and can be used for connecting up to
three CAN devices.
Here is an example of a typical CAN Hub
connection
iC-7 TO HALTECH ECU INSTALLATION
1. Find a suitable place to mount your iC-7
Display Dash. A pull-out mechanical template
is provided in the centre of this booklet if holes
need to be cut in an existing panel.
2. Plug the supplied M5 (small circular
connector) to USB cable into the "Comms"
connector on the dash.
3. Plug the supplied Main Connector Harness
(34-pin Superseal connector) into the 34 pin
connector on the dash labelled "Auxiliary".
4. Plug the DTM-4 to DTM-4 CAN extension
cable into the Main Connector Harness DTM-4
connector.
5. Thread the cables through the hole in the
mounting bracket or panel.
6. Mount the USB connector where it can
be easily accessed for programming and
configuration.
7. Securely mount your iC-7 Display Dash into
your vehicle.
8. Run the DTM-4 cable to your Haltech ECU or
CAN hub.
9. Connect the DTM-4 cable into a spare port on
your Haltech CAN bus.
7
Advertisement
