Kemper SmartMaster Operating Manual page 65

3. Now slide one hand under the side of the filter element, then the other
hand. Pull the filter element out of the product using both hands and
place it on a clean, flat working table.
4. Place the filter element to be replaced in a waste disposal bag and seal
it airtight with a cable tie. Suitable disposal bags are available from the
manufacturer.
5. Lift the new filter element at the bottom and place it on the guiding
profiles of the product using the side bolts. Then, take hold of the front
grip straps with one hand and then the other.
6. Lift the filter element at the front and, at the same time, push it
backwards into the product until it noticeably engages at the end.
7. Now push the pre-filter insertion frames over the newly inserted main
filter.
After replacing the filter inserts, carry out the following work steps:
1. Close the maintenance door until it noticeably engages.
2. Reconnect the power plug to the power supply and switch on the
product again. The green operating light on the switch indicates fault-
free operation of the product.
3. Dispose of the used filter inserts in accordance with the official
regulations. Please request the relevant waste codes from the local
waste disposal service.
4. Finally, the maintenance area must be cleaned, e.g. with an industrial
vacuum cleaner of dust classification 'H'.
NOTE
Observe the information printed on the filter element when changing
the filter.
1502764-01
Fig. 11: Information for filter change
- 65 -
EN