Advertisement
SET UP AND OPERATION
• Follow the specific model Bead Roller
Instructions for complete Bead Roller set-
up and operation. If the Instruction Manual
originally supplied with an Eastwood Bead
Roller is unavailable, contact Eastwood at
www.Eastwood.com or call 1-800-345-
1178 to request a replacement.
• Install Dies so that the outer edge of the
flare of the Positive Die just meets the
stop face of the Negative Die (FIG 1).
• Adjust the spacing between the Dies to
allow for the gauge of metal to be formed
(FIG 2).
• Slowly feed the metal panel between the
Dies keeping the edge firmly against the
stop face of the Negative Die (FIG 3).
STORAGE
• Apply a thin film of light oil or rust-
preventive to all bare steel areas.
• Store in a clean, dust-free, dry, dampness-
free area, preferably covered with plastic.
ADDITIONAL ITEMS
#51088
Shrinker/Stretcher Set
#13475
Eastwood Electric Metal Shears
#11797
Throatless Shear
#14042
Versa Bend Sheet Metal Brake
#20254
Eastwood 24" Slip Roll
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com
© Copyright 2018 Easthill Group, Inc.
If you have any questions about the use of this product, please contact
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
800.343.9353 eastwood.com
FIG. 1
FIG. 2
FIG. 3
8/18
Instruction item #20269Q
Positive
Die
Stop
Face
Negative
Die
Rev 1
Advertisement
