Casio QT-6000 Training Manual page 63

Changing the WEP address
For security reasons you should change the WEP address please
follow the sequence below to change the WEP
1. Use AP with QT6000 default ID and key.
2. Init ECR#1 with DHCP server ON
Init #2 onward as we did it
3. Change ECRs ESSID and WEP key at master.
Send ESSID and key information to other terminal via inline(via
RF in this case).
Note: New ESSID and WEP becomes effective AFTER flag clear.
4. Set Access Point with new ESSID and key
5. Perform flag clear ONE BY ONE
Start from terminal #1, terminal #2 should then perform a flag clear
when Terminal #1 has completed the flag clear process continue
the procedure until you have completed all terminals
6. If for some reason a new terminal is added to the network,
Please enter the IP address manually.
You should start straight away by changing ESSID and the key for
Access Point.
By using the above sequence you can prove that all hardware
(access point and RF cards) are working correctly
This will also prove that the network is set up correctly and that the
network is working under the default settings for Wep or ID.
63