Aaeon AGD-312D Manual page 43

L C D D i s p l a y
Serial Interface
• EIA 232E (Serial RS-232), DCE configuration. 8 Data
Bits, 1 Stop Bit, No Parity, Full Duplex.
Communication Parameters
• Baud Rate 9600 bps
• 8 Data bits, 1 stop bit, no parity only.
Interface - USB
Compliant to USB Revision 1.1. If the USB is connected to the
controller, the controller will communicate over the USB and not
over the serial port. However, the USB will never supply the
power to the touch screen control board. The touch screen
control board can be powered on automatically.
Operating Modes
Full Touch Smart Set protocol. Emulation of E281A-4002
protocol can be selected by Smart Set command.
Initial/ Stream/ Un touch/ Z-axis Enable Modes.
Touch Resolution: 2048 x 2048, size independent.
Conversion Time: Approximately 20 ms per coordinate set.
A G D - 3 1 2 D
Chapter 4 Driver Installation
4-3