Exposure Delivery Procedure; Figure 9 : Home Screen; Figure 10 : X-Ray - Ready; Figure 11 : X-Ray - Exposing - hatch X-RAY Operating Manual

4.7. Exposure Delivery Procedure

The moment the console displays the Home screen, the unit is ready to deliver
an exposure. This section describes the preparations that can be done before
delivering an exposure and what happens during the procedure.
In order to avoid accidental exposure, the user is advised to put the
console in the mode selection screen. ("Figure 15").
NOTE

Figure 9 : Home screen

Figure 10 : X-Ray - Ready

Figure 11 : X-Ray - Exposing

28
Bring the console back to home screen by pressing
the MODE key. If necessary, make the following
changes.
Change the Preset Mode by performing the
procedure in section "5.1. Selecting a Pre-set Mode".
Change the Preset by performing the procedure in
section "5.2. Selecting a Pre-set".
Change the film speed by performing the procedure
in section "5.3. Modifying Exposure Parameters".
Now press Exposure Switch or Remote Exposure
Button on the Doorbell switch to initiate the exposure.
Here the unit prepares itself to deliver the exposure.
This stage might take a few seconds. Verify that an
audible beep occurs and the X-Ray status indication
LED illuminates green.
Stop or abort an exposure by simply pressing any
key other than the Exposure Switch.
The Exposure Switch must be kept
depressed throughout the entire exposure.
Releasing the Exposure Switch before
the end of the exposure terminates the
NOTE
emission with the message displaying
"X-RAY ABORTED".
Verify that an audible beep occurs and the screen
shows the radiation icon while the exposure is
being delivered. The X-Ray status indication LED
also illuminates orange.
If you need to abort while delivering an
exposure, simply release the Exposure
NOTE
key.
HATCH X-RAY Operating Manual