Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for SP01 JEANETTE
Summary of Contents for SP01 JEANETTE
- Page 1 JEANETTE DESIGNED BY TOM FEREDAY ASSEMBLY INSTRUCTIONS...
- Page 2 DISCLAIMER THE ASSEMBLY INSTRUCTIONS ARE TO BE USED AS A GUIDE SHOWING THE CONCEPT OF THE TABLE. IT WILL NOT BE NECESSARILY IDENTICAL TO THE TABLE YOU HAVE PURCHASED. ENSURE THAT ALL STEPS ARE FOLLOWED IN THE CORRECT ORDER AND THAT NO STEP IS LEFT OUT.
- Page 3 JEANETTE TABLE PACKAGING PARTS BOX WITH METAL STRUCTURE BOX WITH TOP METAL STRUCTURE, 4 THICK METAL WASHERS, MARBLE OR TERRACOTTA TOP 4 ADHESIVE PLASTIC BUMPERS, 4 SCREWS, 4 ADHESIVE PLASTIC FEET p. 3 © Copyright 2019 SP01 Design. All rights reserved.
- Page 4 REMOVE THE TABLE STRUCTURE FROM THE PACKAGING, PLACING IT UPSIDE DOWN ONTO A SOFT AND CLEAN SURFACE SUCH AS A BLANKET IN ORDER TO PROTECT THE LACQUER SURFACE. STICK THE ADHESIVE PLASTIC FEET ONTO THE METAL FEET. p. 4 © Copyright 2019 SP01 Design. All rights reserved.
- Page 5 S P Ø 1 D E S I G N . C O M JEANETTE TABLE TOP ASSEMBLY PLACE THE SELF ADHESIVE RUBBER PADS ON TOP OF THE SCREW HOLES, PAYING ATTENTION THAT THE HOLE IS NOT BEING COVERED BY THE RUBBER. p. 5 © Copyright 2019 SP01 Design. All rights reserved.
- Page 6 S P Ø 1 D E S I G N . C O M JEANETTE TABLE TOP ASSEMBLY THIS STEP IS ONLY REQUIRED FOR JEANETTE TABLE WITH MARBLE TOP: PLACE THE METAL WASHERS ON THE METAL STRUCTURE WITHOUT COVERING THE HOLE. p. 6 ©...
- Page 7 JEANETTE TABLE TOP ASSEMBLY PLACE THE TOP ONTO THE METAL STRUCTURE, TAKING CARE THAT THE HOLES IN THE TOP ALIGN WITH THE STRUCTURES FIXING POINTS. FIX ALL THE SCREWS WITHOUT OVERTIGHTENING. p. 7 © Copyright 2019 SP01 Design. All rights reserved.
- Page 8 S P Ø 1 D E S I G N . C O M JEANETTE TABLE p. 8 © Copyright 2019 SP01 Design. All rights reserved.
Need help?
Do you have a question about the JEANETTE and is the answer not in the manual?
Questions and answers