Tuning into a station directly
Enter the frequency of a station directly by
using the numeric buttons.
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
You can also use MEMORY/ENTER on
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
Changing the AM tuning scale
(Models of area code AU only)
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
Press ?/1 to turn off the
While holding down TUNING
MODE, press ?/1.
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
All preset stations will be erased when you change
the tuning scale.