6: Preparing The Receiver And The Remote - Sony STR-DH500 Operating Instructions Manual

6: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Connect the AC power cord (mains lead) to a
wall outlet.
Notes
• Before connecting the AC power cord (mains
lead), make sure that the stripped end of the
speaker cords are not touching each other between
the speaker terminals.
• Connect the AC power cord (mains lead) firmly.
AC power cord (mains lead)
FRONT
L
ROUND
L
R
AKERS
To the wall outlet
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
?/1
?/1
INPUT SELECTOR
MEMORY/
INPUT MODE TUNING MODE TUNING ENTER
PHONES
MEMORY/ENTER
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
"PUSH" and "ENTER" appears on the
display alternately.
3
Press MEMORY/ENTER.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
MASTER VOLUME
2CH/
A.DIRECT A.F.D. MOVIE MUSIC DISPLAY DIMMER MUTING
23 GB