Switching The Server On And Off - Fujitsu PRIMERGY RX2530 M4 Operating Manual

Starting up and operation
6.3

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching
●
on the server, switch the server off immediately (see chapter
"Troubleshooting and tips" on page
The On/Off button does not disconnect the server from the mains
●
voltage. To completely disconnect it from the mains voltage, remove
all power plug(s) from the socket(s).
Do not move, strike, or shake the server when it is turned on. This can
●
damage the hard disk in the server and cause data loss.
Turn the server on when the temperature is in its operating
●
environment range (10–35°C). For details on the operating
environment, refer to "Safety Precautions". When operating the
device outside of this operating environment, the server may operate
improperly and data loss may occur. Furthermore, Fujitsu cannot be
held responsible for any related damage, malfunction, or loss of data,
etc.
Be sure to wait for 10 seconds or more after shutdown before turning
●
the server on again.
After connecting all power cords, wait at least 60 seconds before
●
pressing the On/Off button.
Switching the server on
The AC connected indicator lights up green (standby mode) when the server is
connected to the mains.
I
It takes about 60 seconds until power-on becomes possible.
– Starting up for the first time:
For Japan, please refer to " はじめにお読みください ".
Ê Press the On/Off button.
Ê Insert the ServerView Suite Installation DVD in the ODD.
72
83).
Operating Manual
RX2530 M4