Table of Contents
Advertisement
Figure 6
1. Stabilizer bracket
2. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in
Figure
7. Secure the pivot frame to the
machine frame using 2 bolts (5/16 x 1 inch) and
2 locknuts (5/16 inch).
Figure 7
1. Machine frame
2. Locknut (5/16 inch)
3. Hole
3. Secure the pivot frame to the bottom of the
machine frame using 2 self-tapping screws (5/16
x 3/4 inch) as shown in
g030494
g030494
3. Locknut (5/16 inch)
g028227
4. Bolt (5/16 x 2-1/2 inches)
5. Pivot frame
Figure
8.
1. Self-tapping screw (5/16 x
3/4 inch)
4. Attach the draw bar decal 1.3 cm (1/2 inch) to
the left of the attachment mount
1. Draw bar decal
5. Install the bent, flared end of a rod into the keyed
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame
(Figure
10).
Note:
Repeat this step for the right side of the
machine.
8
Figure 8
2. Pivot frame
(Figure
Figure 9
g028174
9).
g028305
Advertisement
Table of Contents
