Operation; Emptying The Grass Bags - Exmark Quest 135-0332 Operator's Manual

60 inch bagger
Table of Contents

Advertisement

Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.
Note:
Overall width of unit with bagger: 67.7 inches
(172 cm).
WARNING
To avoid personal injury, follow these
procedures:
• Become familiar with all operating and
safety instructions in the Operator's
Manual for the mower before using this
attachment.
• Never remove the discharge tube, bags,
bagger top, or the chute while the engine
is running.
• Always shut the engine off and wait for all
moving parts to stop before clearing an
obstruction from the bagging system.
• Never do maintenance or repairs while the
engine is running.
WARNING
Without the grass deflector, bagger tubes or
complete bagger assembly mounted in place,
you and others are exposed to blade contact
and thrown debris. Contact with the rotating
mower blade(s) and thrown debris will cause
injury or death.
• Always install the grass deflector when
removing the bagger and changing to side
discharge mode.
• If the grass deflector is ever damaged,
replace it immediately. The grass deflector
routes material down toward the turf.
• Never put your hands or feet under the
mower.
• Never try to clear the discharge area or
mower blades unless you move the power
take off (PTO) to off and rotate the ignition
key to off. Also remove the key and pull
the wire off of the spark plug(s).
• Turn off the engine before unclogging the
discharge chute.

Emptying the Grass Bags

Be careful when lifting or handling a grass bag that is
full. To empty the grass bags:
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
N
-L
EUTRAL
OCK
remove the key, engage the parking brake and
wait for all moving parts to stop before leaving
the operating position.
3. Open (raise) the bagger top
4. Compress debris into the bags. With both
hands, lift up on the bag and unhook it from the
retaining bracket. Empty the bag. Repeat the
procedure for the other bag.
5. Install the bags by sliding the bag frame hooks
onto the retaining brackets
14
position, shut off the engine,
(Figure
21).
G005758
Figure 21
(Figure
22).
g005758

Advertisement

Table of Contents
loading

Table of Contents