Clearing Obstructions From The Bagger; Removing The Bagger; Using The Draw Bar - Exmark Quest 135-0332 Operator's Manual

60 inch bagger
Table of Contents

Advertisement

4
3
g028327
Figure 22
1. Bag
2. Bagger frame
6. Lower the bagger top onto the bags.
Clearing Obstructions from
the Bagger
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, set the parking brake and wait for
all moving parts to stop before leaving the
operating position.
3. Check the grass bags and empty them if they
are full.
4. Remove and separate the discharge tube and
chute from the bagger top and mower. Using
a stick or similar object, carefully remove and
clear the obstruction from the mower, discharge
tube, chute, and the bagger top.
5. After you remove the obstruction, install the
complete bagger system and resume operation.
1
2
3. Retaining bracket
4. Bag-frame hook

Removing the Bagger

CAUTION
Failing to remove the front bagger weights
from lever steer models and operating the
machine without the bagger attachment may
cause an unstable condition which could
result in a loss of control.
• Always remove the front weights (where
required) when removing the bagger
attachment.
• Never operate the machine without the
bagger attachment and the front weights
(where required) still installed.
The bagger can be removed by repeating the Setup
sections from all installed bagger related kits in
reverse order. If weights are installed, always remove
the front bagger weights when removing the bagger
attachments.
Note:
It is only necessary to remove the cutoff baffle
when installing a mulching kit.

Using the Draw Bar

g028327
The bagger support bracket has a draw bar feature
that can be used for towing.
Read and understand all the operating instructions
of the machine.
When turning, slow down and observe the
clearance.
Make wide turns and keep towed equipment clear
of the towing vehicle.
The maximum draw bar pull is 36 kg (80 lb).
Excessive draw bar pull may cause hydrostatic
transmission failure.
g033033
1. Bagger support bracket with draw bar
15
1
Figure 23
g033033

Advertisement

Table of Contents
loading

Table of Contents