Table of Contents
Advertisement
PAIRING AND CONNECTING THE REMOTE CONTROL
If the user happens to factory reset the GVC3200, the remote control will not be paired to the GVC3200
anymore. Or, if in any other instance that the remote control is not paired with the GVC3200 anymore,
please follow the steps below to re-pair and connect the remote control to the GVC3200:
1. Connect a USB mouse or use the virtual remote control in the GVC3200 web UI to navigate in LCD
screen->Settings->Network->Bluetooth.
2. Select
and click on "Search For Devices".
3. On the remote control, press "OK" and digit 5 keys at the same time for about 5 seconds.
4. Users shall see "GS-RCU" followed by the last 4 digits of the remote control MAC address under
"Available Devices".
5. The pairing and connecting process will be triggered.
6. Once connected, the remote control icon in the top status bar will light up
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
1. Please use the proprietary factory remote control that comes with the GVC3200.
2. The GVC3200 could connect to multiple remote controls, but only one remote control at a time.
Factory reset might be required for your GVC3200 before pairing and connecting a remote control
that belongs to another GVC3200.
--------------------------------------------------------------------------------------------------------------------------------------------
USING MOUSE & KEYBOARD
When the USB mouse is plugged into the GVC3200, users could make the following operations with the
mouse.
1. Single click the left key of the USB mouse to perform the following operations:
Access menu
Check in the checkbox or enable/disable an option
Bring up the drop-down list when clicking on a combo box.
Switch input methods in the input box, tap on the corresponding buttons on the soft keyboard to
input characters. (Note: Pressing the left key of the USB mouse on
about 3 seconds can switch to "Always use upper case" in English input method.)
2. Single click the right key of the USB mouse to exit the current menu in the LCD display device. It will
go back to the previous menu without saving the configurations.
Firmware Version 1.0.0.X
GVC3200 User Guide
.
in the soft keyboard for
Page 22 of 86
Advertisement
Table of Contents
