WilTec 62935 Operation Manual

WilTec 62935 Operation Manual

Submersible pump

Advertisement

Operation Manual
Submersible Pump
62935
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 62935 and is the answer not in the manual?

Questions and answers

Summary of Contents for WilTec 62935

  • Page 1 Operation Manual Submersible Pump 62935 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
  • Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
  • Page 3: Safety Instructions

    Do not use this device to operate swimming pools .  This device must not be added to any kind of domestic water circuit meant for potable water.  © by WilTec Wildanger Technik GmbH Article 62934 Page 3 http://www.WilTec.de http://www.aoyue.eu...
  • Page 4: Installation

    Check, if the plug socket is in pristine conidion and does not show signs of damage or wear.  Ensure that the electrical connections and circuits are sufficiently protected from moisture and  water. Do not allow the pump to run dry.  © by WilTec Wildanger Technik GmbH Article 62934 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
  • Page 5 When setting the float switch, make sure that it does not touch the base before the pump has  shut down as contact might cause the pump to run dry. © by WilTec Wildanger Technik GmbH Article 62934 Page 5 http://www.WilTec.de...
  • Page 6: Troubleshooting Chart

    Input voltage 230V / 50 Hz Flow rate 7500 l/h Max. Immersion depth Max. Delivery head 6,5 m Max. Particle size 5 mm Cable length 10 m © by WilTec Wildanger Technik GmbH Article 62934 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
  • Page 7: Disposal Regulations

    All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.

Table of Contents