Configuring Ir Parameters - HIKVISION DS-2AE5223TI-A User Manual

User Manual of HD-TVI Speed Dome
3. Click the up and down direction buttons to select a desired video standard.
4. Click IRIS+ again to confirm and exit the editing mode.

3.3.6 Configuring IR Parameters

The IR parameter settings are supported by IR speed domes only.
Purpose:
You can configure the IR parameters including the IR sensitivity, n/m LED current, reference height,
reference zoom, and LED control, fan control, switch delay, heat control, and IR correction, etc.
Enter the LED parameter submenu:
MAIN MENU > DOME SETTINGS >IR SETTINGS
 Set the sensitivity of the IR LED.
You can set the SENSITIVITY to HIGH, MEDIUM, or LOW.
 Set the electricity level of the IR LED.
The N/M LED CURRENT and the FAR LED CURRENT refer to the electricity level of the
near/middle IR LED and far IR LED correspondingly. You can set the near/far LED current and the
far LED current to 1~10.
 Set the parameters of IR LED switching.
 ZOOM LIMIT
When the actual zooming rate is larger than the zoom limit, it will switch to the far-distance
IR LED; when it's smaller than the zoom limit, it will switch to the near/medium-distance IR
LED.
 IR CONTROL
LED control can be set to ALL ON (enable all the IR LED), FAR ON (enable far-distance IR LED),
NEAR ON (enable near/medium-distance IR LED), AUTO (enable IR LED automatically
according to the environment illumination), ICR (adjust the IR LED working mode according
to the ICR), and CLOSE (disable IR LED).
 Set the IR LED switch delay.
© Hikvision
IR SETTINGS
SENSITIVITY MEDIUM
N/M LED CURRENT
FAR LED CURRENT
ZOOM LIMIT
IR CONTROL
SWITCH DELAY(S)
BACK EXIT
Figure 3-10 IR Settings
8
8
4
AUTO
2
20