Programming The Remote - Sony STR-DA3400ES Operating Instructions Manual

Programming the remote

You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
The procedure below uses an example in
which a VCR made by a company other than
Sony is connected to the VIDEO 1 IN jacks on
the receiver.
Before you begin, note that:
– You cannot change the settings of PHONO.
– The remote can control only components
that accept infrared wireless control signals.
Be sure to turn on the receiver and point the
remote towards the receiver when performing
the following procedure.
1
THEATRE
SHIFT TV
1 1
VIDEO1 VIDEO2
2,3
4
SAT
7
TUNER PHONO
-/-- 0/10
HDMI1 HDMI2
2CH/
A.DIRECT A.F.D.
1
While holding down RM SET
UP, press AV ?/1.
The RM SET UP button flashes.
GB
104
AMP
2 2 3 3
TV INPUT TV INPUT
BD DVD
5 6
WIDE
MD/ SA-CD/
TV
TAPE CD
8 9
D.TUNING
MULTI
DMPORT
IN
ENT/MEM CLEAR
HDMI3 HDMI4
4
MOVIE MUSIC
2
While the RM SET UP button is
flashing, press the input button
(including TV) for the
component you want to control.
For example, if you are going to control a
VCR connected to VIDEO 1 IN jack,
press VIDEO1.
The RM SET UP and the SHIFT buttons
light up. The input button you selected
(VIDEO1) flashes.
If you press the button for a component of
which you cannot program the remote,
such as DMPORT, etc., the RM SET UP
button keeps flashing.
3
Press the numeric buttons to
enter the numeric code (or one
of the codes if more than one
code exists) corresponding to
the component and the maker
of the component you want to
control.
The input button you selected in step 2
(VIDEO1) lights up. (The RM SET UP
and SHIFT buttons remains lit.)
Note
For a TV remote code value, only numbers in
the 500's are valid.
4
Press ENT/MEM.
Once the numeric code has been verified,
the RM SET UP button flashes twice and
the remote automatically exits the
programming mode. The input button
lights off.
To cancel programming
Press RM SET UP during any step.