Sony STR-DA3400ES Operating Instructions Manual page 99

Performing Auto Calibration
For details on the Auto Calibration, see "9:
Calibrating the appropriate speaker settings
automatically (Auto Calibration)" (page 43).
See "Before you perform the Auto
Calibration" (page 43) before performing the
Auto Calibration.
To operate on the receiver
1
Press GUI MODE repeatedly to select
"GUI OFF".
2
Press AMP.
Receiver operation is enabled.
3
Press MENU.
4
Press V/v repeatedly to select "<AUTO
CAL>", then press
5
Press V/v repeatedly to select "A.CAL
START", then press
measurement.
Measurement starts in five seconds. A
count down is displayed.
Note
While the time is counting down, stand away
from the measurement area to avoid
measurement error.
6
Measurement starts.
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
.
to start the
To cancel Auto Calibration
The measurement will be canceled when you
do the following:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the
receiver.
– Change the volume level.
– Connect the headphones.
– Press GUI MODE.
Tips
• Operations other than turning the receiver on or off
are deactivated during Auto Calibration.
• In the following situations, the measurements may
not be performed correctly or Auto Calibration
cannot be performed.
– when special speakers, such as dipole speakers
are connected.
To confirm/save Auto
Calibration when GUI function
is turned off
1
Confirm the measurement result.
When the measurement ends, a beep
sounds and the measurement result appears
on the display window.
Measurement Display
result window
When the COMPLETE Proceed to step
measurement
process
completes
properly
When the E-
xxx:xx
measurement
process fails
Explanation
2.
See "Message
list after Auto
Calibration
measurement"
(page 48).
continued
GB
99