Using The Remote; Operating Each Component Using The Remote - Sony STR-DA3400ES Operating Instructions Manual

Presetting radio stations
1
Tune in the station that you
want to preset.
For details on the operation, see "Tuning
radio stations" (page 101).
2
Press SHIFT and then press
ENT/MEM.
"MEM" lights up on the display window
for a few seconds. Perform steps 3 and 4
before "MEM" disappears.
3
Press PRESET + or PRESET –
to select a preset number.
30 FM and 30 AM preset numbers are
available. If "MEM" lights off before you
select the preset number, start again from
step 2.
4
Press SHIFT and then press
ENT/MEM.
The station is stored as the selected preset
number. If "MEM"disappears before you
press ENT/MEM, start again from step 2.
5
Repeat steps 1 to 4 to preset
another station.
Selecting a preset station
1
Press TUNER repeatedly to select the
FM or AM band.
2
Press PRESET + or PRESET –
repeatedly to select the preset station
you want.
You can also press SHIFT and then press
the numeric buttons to select the preset
station you want. Then, press
the selection.
You can also press TUNING MODE on the
receiver repeatedly to select "PRESET",
then turn TUNING +/– to select the preset
stations you want.
GB
102

Using the Remote

Operating each
component using the
remote
When you program the remote to control the
following Sony or non-Sony components, you
can use the buttons on the remote that are
marked with circles. Note, however, that some
buttons may not operate your component.
If you want to change the contents of the input
list to match your particular components, see
"Programming the remote" (page 104).
to enter