Control For Hdmi - Sony DAV-DZ340K Operating Instructions Manual

Symptom
Transferring to a USB device
results in an error.
Audio files or folders on the
USB device cannot be erased.
Tuner
Symptom
Radio stations cannot be tuned
in.
FM reception is poor.

Control for HDMI

Symptom
The Control for HDMI function
does not work.
No sound is output from the
system and TV while using the
System Audio Control function.
Karaoke
Symptom
Microphone sound is not output. • Set the karaoke mode to on (page 41).
70
GB
Problems and solutions
• The USB device was disconnected or the power was turned off during erasing.
Delete the partially-erased file. If this does not fix the problem, the USB device
may be broken. Follow the procedure in the operating instructions of the USB
device to format the USB device. If the problem persists, contact your nearest
Sony dealer.
• Check if the USB device is write-protected.
Problems and solutions
• Check that the antenna (aerial) is connected securely. Adjust the antenna
(aerial) or connect an external antenna (aerial) if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic
tuning). Use direct tuning.
• Use a 75-ohm coaxial cable (not supplied) to connect the unit to an outdoor FM
antenna (aerial).
Problems and solutions
• Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 60).
• Make sure that the connected component is compatible with the [CONTROL
FOR HDMI] function.
• Check the connected component's setting for the Control for HDMI function.
Refer to the operating instructions of the component.
• If you change the HDMI connection, connect and disconnect the AC power
cord (mains lead), or have a power failure, set [CONTROL FOR HDMI] in
[HDMI SETUP] to [OFF], then set to [ON] (page 60).
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 49).
• Make sure that the connected TV is compatible with the System Audio Control
function.
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 49).
Problems and solutions
• Connect the microphone to the unit properly.
• Connect a monaural dynamic microphone.