Connecting An Aerial And A Vcr; Switching On The Tv - Sony KD-32NX100U Operating Instructions Manual

3. Connecting an aerial and a VCR

Connecting an aerial only
RF loopthrough
cable (supplied)
Connecting an aerial and a VCR
Scart lead
(not supplied)

4. Switching on the TV

1.
2.
Existing
aerial
1. Connect your existing aerial to the Digital
2. Connect the supplied RF loopthrough cable
3. Connect a lead from the RF output of your
4. Connect a scart lead from the socket marked
5. Connect the VCR to the mains socket and
6. Insert a pre-recorded tape into the VCR and
RF lead (not
supplied)
RF loopthrough
cable (supplied)
1. Connect the TV plug to your mains socket
2. Press the on/off switch in a forward direction to
Note: If the red indicator on the front of the TV is lit the TV
Connect your existing aerial lead to the
Digital socket marked on the rear of the
TV as shown.
Connect the supplied RF loopthrough cable
from the socket marked
socket marked .
socket marked on the rear of the TV as
shown.
from the lower socket marked
to the RF IN socket on your VCR.
VCR to the Analogue socket marked
the TV.
3 s 3 on the rear of the TV to the scart
socket of your VCR (refer to VCR instructions).
switch on.
press the 'PLAY' button. This enables the TV
to locate and store the video channel during
the 'Automatically tuning the TV' procedure.
(220 - 240 V AC, 50 Hz).
switch on the TV.
is in standby mode. Press the TV
the remote control to switch on the TV. Please be
patient as the picture may take a few moments to
appear on screen.
Getting started
to the analogue
on the TV
on
/
button on
5