Table of Contents
Advertisement
Quick Links
GEARED HEAD DRILLING MACHINE
BEFORE USE, ENSURE EVERYONE USING THIS MACHINE READS AND UNDERSTANDS
Serial #............................................
Ver: 1.02 17/03/2022
TGD400
OPERATOR'S MANUAL
240v 1 Phase Version:
415v 3 Phase Version:
ALL SAFETY AND OPERATING INSTRUCTIONS IN THIS MANUAL .
Model # TGD400-1
Model # TGD400-3
Date of Purchase............................
Advertisement
Table of Contents
Related Manuals for Itm TGD400
Summary of Contents for Itm TGD400
- Page 1 TGD400 GEARED HEAD DRILLING MACHINE OPERATOR’S MANUAL 240v 1 Phase Version: Model # TGD400-1 415v 3 Phase Version: Model # TGD400-3 BEFORE USE, ENSURE EVERYONE USING THIS MACHINE READS AND UNDERSTANDS ALL SAFETY AND OPERATING INSTRUCTIONS IN THIS MANUAL .
- Page 2 TGD400 OPERATOR’S MANUAL LIMITED WARRANTY Industrial Tool & Machinery Sales (hereinafter referred to as ITMS) will, within twelve (12) months from the original date of purchase, repair or replace any goods found to be defective in materials or workmanship. This warranty is void if the item has been damaged by accident, neglect, improper service or other causes not arising out of defects in materials or workmanship.
- Page 3 TGD400 OPERATOR’S MANUAL ons. LIMITED WARRANTY PRIOR TO OPERATION SAFETY PRECAUTIONS ht to Industrial Tool & Machinery Sales (hereinafter 1. Power source; ensure that the power Warning! When using electric tools basic safety precautions should always be followed...
- Page 4 TGD400 OPERATOR’S MANUAL MACHINE OPERATION Safety - Peronal 1. Dress properly, do not wear loose clothing or jewellery, they can invite personal injury. Always cover long hair. 2. When operating power tools suitable personal protective equipment must be worn where necessary, including, but not restricted to eye, ear, respiratory and foot protection.
- Page 5 TGD400 OPERATOR’S MANUAL SETUP 1.Internal spline drive assembly. Keep this area 1. Adjustment of head (a)To raise and lower the head, loosen the nuts well lubricated with a good grade grease, insert grease in the hole at the top of spindle pulley located on the right side of the column bracket.
- Page 6 TGD400 OPERATOR’S MANUAL MACHINE PARTS - BASE ITEM PART # DESCRIPTION ITEM PART # DESCRIPTION 10002/40H base 10017/40 bracket 10001/40H column 10112/40 worm shaft 10016/40H elevating body 10113/40 small shaft 10014/40 column lid helical gear 10012/40H locked guide ring 10201/40...
- Page 7 TGD400 OPERATOR’S MANUAL MACHINE PARTS - HEAD ITEM PART # DESCRIPTION ITEM PART # DESCRIPTION retaining ring 20010B head body 20011B head body cover 20012 feed base 20128 support base retaining ring retaining ring 20129 20018B airtight base 20130 knob...
- Page 8 TGD400 OPERATOR’S MANUAL MACHINE PARTS - HEAD www.itmtools.com.au...
Need help?
Do you have a question about the TGD400 and is the answer not in the manual?
Questions and answers