Suzuki AN650Z Manual page 36

Front Brake Lever Adjustment
The distance between the throttle grip
and the front brake lever is adjustable
to 5 positions. To change the position,
push the brake lever forward and turn
the adjuster to the desired position.
When changing the brake lever posi-
tion, always be sure the adjuster
stops in the proper position; a projec-
tion of the brake lever pivot should fit
into the depression of the adjuster.
This motorcycle is delivered from the
factory with its adjuster set on posi-
tion 3.
 WARNING
Adjusting the front brake lever
position while riding can be haz-
ardous. Removing a hand from the
handlebars can reduce your ability
to control the motorcycle.
Never adjust the front brake lever
position while riding. Keep both
hands on the handlebars.
THROTTLE GRIP 4
Engine speed is controlled by the
position of the throttle grip. Twist it
towards you to increase engine
speed. Turn it away from you to
decrease engine speed.
ELECTRIC STARTER SWITCH ""
5
Push in the electric starter switch to
operate the starter motor.
NOTE: If the brake lever is not
squeezed, the starter motor will not
operate.
NOTE: This motorcycle is equipped
with an interlock system for the igni-
tion circuit and the starter circuit. The
engine can only be started if the side
stand is fully up.
NOTE: The headlight will go off when
the electric starter switch is pushed.
NOTICE
Engaging the starter motor for
more than five seconds at a time
can damage the starter motor and
wiring harness from overheating.
Do not engage the starter motor
for more than five seconds at a
time. If the engine does not start
after several attempts, check the
fuel supply and ignition system.
Refer to the TROUBLESHOOTING
section in this manual.
2-25