Panasonic SDR-S100 Operating Instructions Manual page 19

To cancel quick start
Press the menu button, use the cursor button to select [
[ QUICK START]#[OFF]. (P26)
≥ To cancel quick start standby, turn off the
power.
≥ Quick start standby is canceled after
5 minutes have elapsed.
In this case, the unit cannot be
quick-started and it takes longer for it to
start operating.
≥ Quick start standby is canceled if the
mode dial is switched to a mode other
than motion picture recording mode or
still picture recording mode.
≥ Since about half the power of normal
recording is used in quick start standby,
using quick start reduces the recordable
time.
≥ If quick start is not set, it takes longer for
this unit to start operating, but the
amount of power consumed when the
LCD monitor is closed is reduced.
SETUP]#
≥ When the LCD monitor is opened in
quick start standby status, the zoom
magnification is set to the 1k
(approximately). This may cause the size
of the image to be different from the size
before standby status was established.
≥ When this unit is quick-started with the
white balance on automatic, it may take
some time until the white balance is
adjusted if the scene being recorded has
a light source different from the scene
last recorded. (When the MagicPix
function is used, however, the white
balance of the scene last recorded is
retained.)
19
VQT0T50