EN
6.2. Cleaning
The BEKOMAT
is cleaned with a damp (not wet) cotton or disposable cloth as well as mild, commercially available
®
detergent / soap.
Spray a little detergent onto the clean cotton cloth or disposable cloth and carefully wipe the component. Then dry using a clean
cloth or let it dry at room temperature. Observe all hygiene instructions applicable on the site.
NOTE
Damage to device caused by improper cleaning
Cleaning with a wet cloth, hard or pointed implement or aggressive detergent can damage the
components and integrated electronic components.
•
•
•
Cleaning
A. Clean container:
Do not press the TEST button, rather:
•
Shut off the supply line
•
Carefully open the manual
condensate drain on the container
•
Residual pressure flushes the
container
B. Clean sensor tube:
•
Disassemble the flange on the top
side of the container (loosen hose
connection, cable connector and
flange screws, lift out flange with
electronics and sensor tube)
•
Only clean the sensor tube from the
outside
•
Assemble components properly
C. Clean valve:
Only loosen the screw that are not
colour-marked! Coloured screws have
been set in the factory and must not be
adjusted!
BEKOMAT
8/9
®
Never clean the device with a dripping wet cloth.
Do not use aggressive detergents.
Never clean the device with hard or pointed implements.
B
A
Installation and operation manual
C
21