Table of Contents
Advertisement
EN
1.4. Transport and storage
Despite our best efforts, transport damage cannot be excluded. Please therefore remove all packaging material immediately
after receipt and inspect the device for any possible transport damage. If you detect such damage, immediately notify the carrier
company and BEKO TECHNOLOGIES GMBH or one of its agents.
CAUTION
Damage caused during transport or storage
Inappropriate transport or storage, or the use of unsuitable lifting equipment, might cause damage to the
device.
•
•
•
•
NOTE
Recycling packaging material
•
BEKOMAT
8/9
®
The device may only be transported and stored by trained authorised and skilled personnel.
If you detect any damage, do not put the device into operation.
Always adhere to the permissible storage and transport temperatures.
Never expose the device to continuous, direct sunlight or heat radiation.
The packaging material is recyclable. Dispose of the packaging material according to the applicable
statutory regulations.
Installation and operation manual
The device must be stored in the original
packaging. Seal the packaging and store it in a
dry and frost-free room. Ensure that the ambient
conditions do not fall below or exceed the limits
specified on the type plate.
Always take suitable measures to protect the
device against the elements even in a packaged
condition.
While in storage, secure the device so that it
cannot topple over or fall, and protect it against
vibration.
7
Advertisement
Table of Contents
