Enabling And Disabling Auto Projection Off; Auto Projection Off Projection Light Control - Casio XJ-UT Series User Manual

Enabling and Disabling Auto Projection Off

Auto Projection Off is disabled under initial projector default settings. To enable Auto Projection Off,
change "Screen Settings 3 Auto Projection Off" (page 62) on the Setup Menu to "Enable".

Auto Projection Off Projection Light Control

Projection Light Off Conditions
If the image input signal from the input source device to the projector is lost for some reason while
projection is being performed, the no signal screen (page 62) or the network standby screen* appears
first. If no operation is performed for about 10 seconds, the projection light turns off and audio
becomes muted.
The following message will be displayed for about five seconds before the light turns off: "Auto
Projection Off is enabled. The projector will stop projecting."
Auto Projection Off operation is not affected by whether audio is being input.
* The network standby screen appears when the source setting is "Network". It indicates that the
projector is standing by for a network connection (wired LAN or wireless LAN). For details about
projection using a network connection, refer to the separate "Network Function Guide".
Regardless of the current Auto Projection Off setting, Auto Projection Off is not triggered while any
one of the following conditions exists.
 If there has been no projection from any input source since the projector was turned on.
 While a template (page 53), the countdown timer (page 56), or a test pattern (page 55) is being
projected.
 While an auto input search operation is in progress (page 43).
Projection Light Restoration Conditions
The projection light will turn back on when the currently selected input source resumes signal input
(or, in the case of the "Network" input source, a network connection starts projection), or when a key
operation is performed on the projector or its remote controller.
Auto Power Off Following Projection Light Off
If the "Auto Projection Off" setting is "Enable", the Auto Power Off trigger time is fixed at 20 minutes
after the projection light is turned off. This is true regardless of the current Auto Power Off setting
(page 64).
Projector Operation While the Projection Light is Off
 The POWER/STANDBY indicator (green) flashes slowly while the projection light is turned off by the
Projection Light Off function.
 Auto Power Off will be triggered if no projector key operation is performed for approximately 20
minutes after the projection light turns off.
48