Connecting a Scientific Calculator (Network Models Only)
After connecting a scientific calculator to the projector, you will be able to project the calculator's
screen image. For information about connectable calculators, go to the CASIO website.
XJ-UT312WN, XJ-UT352WN
Projector Terminal
USB-A/DC 5V
or
USB-A
Important!
To project the screen image of a scientific calculator, select "CASIO USB Tool" as the
projector's input source. For information about how to do this, see "Changing the Input
Source Manually" (page 45).
If you experience problems after connecting a scientific calculator to the projector, disconnect
the USB cable from both devices. Next, use the cable to re-connect them.
For information about scientific calculator operation, refer to its user documentation.
SERIAL Terminal (Projector Control Using Commands)
You can control the projector by sending it commands from a device (computer, other RS-232C
controller device) connected to the projector's SERIAL terminal.
SERIAL terminal
XJ-UT Series
Projector Terminal
SERIAL
For details about control commands, see "Projector RS-232C Control" (page 85).
XJ-F21XN, XJ-F211WN
Connection Cable
USB cable
USB Type A
SERIAL terminal
XJ-F Series
Connection Cable
Serial cable (cross)
D-Sub9 pin
37
XJ-S400UN, XJ-S400WN
Calculator Terminal
USB port
Type B mini
SERIAL terminal
XJ-S Series
Other Device Terminal
RS-232C terminal