Table of Contents
Advertisement
To re-fit the aluminium grease filter after cleaning
•
Replacement of the aluminium grease filter is a straight reversal of
the removal process.
Changing the charcoal filter (re-circulating only)
To ensure best performance of your extractor, you should replace the
charcoal filter every four to six months, depending on use.
To attach a charcoal filter:
•
Remove the grease filter as described above.
•
Position the charcoal filter in the aperture. It is a tight fit so should
remain in place until the grease filter is replaced to lock it into
position.
•
Finally, replace the grease filter.
IMPORTANT: Steam cleaners must not be used to clean this
appliance.
If your extractor is not working:
1. Check that the mains supply has not been switched off.
2. Check that the fuse in the spur has not blown.
The LED Lamps
The LED lamp strips are long-life items that are not designed to be
replaced by the user. In the unlikely event of a lamp failure, contact
CDA Customer Care for assistance.
7
Advertisement
Table of Contents
