CDA 3B10 Installation, Use And Maintenance Manual page 12

5. Insert the two lower fixings
through the mounting holes
in the extractor body and into
the wall to lock the appliance
in position. The location of the
holes is shown in fig. 5.
For recirculating installation:
When installing for recirculation
only the lower chimney section is
used.
1. Make any necessary electrical
connections within the
chimney area. Note: the
isolation switch must not be in
this area, see comment under
"Mains electricity connection"
above.
2. The lower chimney section simply slots into the top of the extractor
body. The spring clips at either side of the motor housing help
locating it in position.
3. Slot the top cover into its location on top of the chimney section
(Fig. 6).
12
Fig. 5
Fig. 6