CDA 3B10 Installation, Use And Maintenance Manual page 11

Mounting Your
Extractor
To mount the hood onto a wall:
1. Use the template supplied to
mark out five fixing holes in the
wall, then drill these using a
suitable drill for the type of wall:
• Three holes for the top
hanging bracket.
• Two holes toward the bottom for bracing the extractor body.
Note: The size required for the holes is dependent on the wall fixings to
be used.
2. Remove the grease filter from the underside of the appliance.
3. Screw the hanging bracket ("A" in Fig. 4) to the wall using three
suitable fixings.
Note: the screws supplied are suitable for solid masonry walls only:
Dedicated fixings will be required for dry lined, partition or other types of
walls.
4. Lift the extractor onto the hanging bracket (Fig. 5).
Fig. 4
A
11