Advertisement
6. BIOS Configuration
The motherboard provides a 4MB, 3.3V, 32-Pin PLCC package Firmware Hub chips that
can be updated using provided BIOS Utility. The Setup Utility stores data about mother-
board components and the configuration of devices that are connected to it. The informa-
tion is used to test and initialize components at start up time and to make sure everything
runs properly when the system is operating. The Utility provide you the opportunity when-
ever you need to install your motherboard, change its default value for better performance
or reconfigure your system when new components or device are used. We will suggest
updating your BIOS if you have problems with your motherboard and you know that the new
BIOS revision will solve your problems. Unnecessary updating may result more problems
for your motherboard.
When you start up the system, the system provides the opportunity to run this program.
This appears during the Power On Self Test (POST), press <DELETE> key to call up "Setup
Utility". If you are a little bit late pressing the mentioned key(s), POST will continue with its test
routines. If you still need to call setup, restart the system by pressing <Ctrl> + <Alt> + <Delete>
keys, or press the reset button on your chassis.
You can also restart by turning system off and then back on again. But do it only first 2 way fail.
The below table, CMOS Setup Utility will appear on screen after call up.
Note : If you are not sure how to configure the setup utility, we suggest that you select auto
configuration with Optimal Settings on the CMOS Setup Utility screen, then exit saving
changes. This load optimized default settings for normal use.
28
M81E / M81DC2 / M812-FX Series User's Manual
Advertisement
