Table of Contents
Advertisement
on the board. For working with external power source you should use the contacts
+VPWR and Ʇ.
Contacts for
connecting an
external power
source
7. When the power is connected at the first time the device automatically switches to
the "Active" mode and starts registration in the network. But if the device with
connected battery or an external power has been switched to the "Storage" mode
(by the pressing on the start button more than 5 sec) then you need to press the
button to start.
Start button on the
board
8. By the laptop make sure that the device successfully sends the data.
9. Assembling the device.
10. DIN-rail mounting or another available way to mount the device on the object.
Before connecting the device to the network, make sure that its
registration data is entered in the network - Device EUI, Application EUI
and Application Key for OTAA, or Device address, Application session key
and Network session key for ABP
16
Vega TP-11 / User Manual
Connector for
battery
Revision 12 of 12 October 2021
Advertisement
Table of Contents
