Table of Contents
Advertisement
CONNECT TO POWER
Connecting the Smart Hubs to power:
RED
Smart Hub hardwire cables are color coded,
for POSITIVE (+) and
BLACK for NEGATIVE (-). Connect the
RED
cable to the POSITIVE (+)
battery clamp as illustrated. The POSITIVE battery post will be slightly
larger than the NEGATIVE post, and will be marked with a PLUS (+)
RED
sign. There may also be a
protective cover over the positive battery
post. Connect the BLACK cable to the NEGATIVE (-) battery clamp as
illustrated. The NEGATIVE will be marked with a MINUS (-) sign. There
may also be a BLACK plastic protective cover over the negative battery
post.
NOTE: After connecting the Smart Hub to the car battery, the LED
power indicator will flash Blue. If the LED power indicator does not flash
once connected, please double check your power connections.
The Smart Hub has built-in voltage protection to prevent car battery
from draining in case the lights are accidentally left on. The lights
will be turned off automatically and the Smart Hub will be on standby
mode when the voltage drops to approximately 12V. Once on
standby mode, if the car battery is producing below 12V, do not turn
on the LED lights until your next engine start or when the power is
Power Indicator
back to 12V or above.
WARNING: DO NOT mix up the cables or allow the metal ends to touch together because this may damage the
battery, charging system and/or electronics on a vehicle. When installing, please make sure your engine is not running.
7
Advertisement
Table of Contents
Need help?
Do you have a question about the Formula DRIFT PSL PRO Series and is the answer not in the manual?