Installing the LED strips:
1. Choose your desired location to install the light
strips (Refer to the figures on the right for the
recommended installing location for each LED strip.)
2. Clean the surface thoroughly with the alcohol pads
provided and let it dry completely. Apply adhesion
promoter to the same area.
3. Peel off the 3M™ tape backer at the bottom of the
light strips and carefully apply to the desired area.
4. Use the wire mounting brackets and screws if
needed to secure the LED strips or wires as shown
below. You may want to drill pilot holes before driving
in any screws.
INSTALLATION
Side Glow LED
5
Need help?
Do you have a question about the Formula DRIFT PSL PRO Series and is the answer not in the manual?
Questions and answers