Racal Instruments X Series Manual page 45

1260-100X User Manual
Racal Instruments © 2005
2. Send a *IDN? command to the Option-01T, then read the
response. It should be in the following format:
Racal Instruments,1260A Option-01T,<serial
num>,<revision>
where <serial num> is the serial number, and <revision>
is the revision level of the firmware.
responds with a message in this form, then proceed to step 3.
Otherwise, go to step 8.
3. Execute the Racal Instruments 1260-Series soft front panel
program. It should display a list of all plug-ins and 1260-Series
modules that are connected to the Option-01T. If it does not
display a list, then go to step 8. Otherwise, proceed with step
4.
4. If the list displayed in step 3 is complete, then go to step 5.
Otherwise, go to step 10.
5. Since the list of plug-ins is complete, the Option-01T is
successfully communicating with all of the plug-ins. If you still
have other communication difficulties, contact Racal Customer
Support.
6. If this fails to correct the problem, then contact Racal Customer
Support.
7.
Try to isolate the problem to a single 1260-100X Carrier or
1260-Series module by removing others from the chassis.
Remember the Option-01T is installed in the left-most module
in the group.
For problems with Option-01T, please refer to the user manual of
the controlling carrier with the Option-01T installed.
If the Option-01T
Troubleshooting C-3