Uploading, Downloading Waypoint, Route Data - Furuno GP-32 Operator's Manual

7.13 Uploading, Downloading
Waypoint, Route Data
Waypoint and route data may be downloaded
to a PC or uploaded from a PC to your unit.
Wiring
Your equipment provides a wiring diagram
which shows how to connect to a PC using a
DSUB 9-pin connector (EIA-574). You may
display it as follows.
1. Press the [MENU] key once or twice to
open the menu.
2. Choose I/O SETUP and then press the
[ENT] key.
3. Choose WIRING INFO and then press the
[ENT] key to display the wiring diagram.
WIRING INFO
1 TD-H WHITE
2 TD-C/SG
3 SD
4 RD
5 +
RED
6 -
BLACK
7 FG -
GP-32/37 12/24VDC
Wiring diagram, using
DSUB 9-pin connector
Note: A DSUB 25-pin (EIA-232) may also be
used to make the connection. In this case the
wiring diagram is as follows.
1 TD-H WHITE
2 TD-C/SG
3 SD
4 RD
5 +
RED
6 -
BLACK
7 FG -
Wiring diagram, using
DSUB 25-pin connector
PC/AT DSUB-9
5 GND
BLUE
2 RXD
YELLOW
3 TXD
GREEN
4 DTR
6 DSR
7 RTS
+
8 CTS
7 GND
BLUE
3 RXD
YELLOW
2 TXD
GREEN
4 RTS
5 CTS
6 DSR
+
20 DTR
Setting for communication software on
PC
Baud Rate: 4800 bps
Character Length: 8 bit
Stop Bit: 1 bit
Parity: None
X Control: XON/OFF
Downloading/Uploading between PC
and GP-37/GP-32
Waypoint data and route data can be
downloaded/uploaded between a personal
computer and the GP-37/GP-32.
Note 1: There are two kinds of data for route
data: route data and route comment data.
Note 2: No position fix is available during
uploading or downloading.
Downloading data to a PC
1. Press the [MENU] key once or twice to
open the menu, choose I/O SETUP and
then press the [ENT] key.
I/O SETUP
DATA1 : NMEA-REM1
DATA2 : NMEA-REM
NMEA VER : VER2.0
SAVE WPT/RTE
LOAD WPT/RTE
LOAD WPT YEOMAN?
WIRING INFO?
I/O SETUP menu
2. Choose SAVE WPT/RTE
3. Press the [ENT] key.
SAVE WPT/RTE
ALL WPTS/ROUTES
WILL BE SAVED TO PC.
SET PC PORT TO 4800
8 BIT, P-N, S1, XON/OFF.
CONTINUE?
SAVE WP/RTE display
4. Press the [ENT] key.
7. OTHER FUNCTIONS
PC?
PC?
PC?.
43