Stopping The Engine - MG 6 Manual

1 Please place the remote key on the bottom of centre
console cup holder with the button upward (as
shown in figure).
2 Depress the brake pedal, and press START STOP
button to start the engine.
After the battery is replaced and the car leaves the
interference area, the keyless starting procedure can still
not be used normally. Seek an MG Authorised Repairer.
IMPORTANT
Application scope of standby starting procedure:
• The remote key battery drains and cannot be
replaced in time.
• When the vehicle is disturbed by strong signals, use
the standby starting procedure to drive the vehicle
away from this area, until the keyless start procedure
restores normal function.

Stopping the Engine

Stopping the engine:
1 After bringing the car to a stop, ALWAYS press the
brake pedal;
172
Starting & Driving
2 Apply the electronic parking brake;
3 For vehicles with automatic transmission, ensure that
the shift lever is in P position;
Note: If the parking brake is applied but the shift
lever is not fully in the parking (P) position, then
there maybe be a risk of the vehicle suddenly
moving and causing injury to yourself or others
when starting the engine.
For vehicles with manual transmission, place the shift
lever in N position.
4 Press START STOP button to shut down the engine.
Note: When the engine needs to be shut down in
emergency, press the START STOP button for more
than 4 seconds to shut down the engine.
Note: After strenuous towing or driving at high speed
(particularly in hot weather), it is recommended to
allow the engine to idle for a few minutes before
switching off, which enables the cooling system to
work continuously to lower the engine compartment
temperature.