MG 6 Manual page 69

Open the Sunroof
Tilt Open
Press the sunroof switch (5) to automatically tilt and open
the rear edge of the sunroof. You can stop the movement
of the sunroof at any time by pressing the sunroof switch
again.
Slide Open
Push the sunroof switch backwards to the 1st position (1)
and hold, the sunroof will automatically slide open. You can
stop the movement of the sunroof at any time by releasing
the switch. Push hard the sunroof switch backwards to
the 2nd position (2) and then release, the sunroof will
automatically open to the end. You can stop the movement
of the sunroof at any time by pushing the switch backwards
again.
Close the Sunroof
Push the sunroof switch frontwards to the 1st position (3)
and hold, the sunroof will automatically close. You can
stop the movement of the sunroof at any time by releasing
the switch. Push hard the sunroof switch frontwards to
Instruments and Controls
the 2nd position (4) and then release, the sunroof will
automatically close to the end. You can stop the movement
of the sunroof at any time by pushing the switch frontwards
again.
"Anti-trap" Function
When the sunroof is being closed by sliding automatically, it
will stop closing and open automatically after encountering
an obstacle to allow to remove the obstacle.
Note: The anti-trap function of sunroof glass only
works when it is being closed by sliding.
Initialization of Sunroof
If power failure occurs when sunroof glasses are in motion,
or after the sunroof assembly or sunroof glass is replaced,
it is required to make initialization operation after power
on.
Press the tilt-open switch of the sunroof to make the
sunroof completely open, press the switch again for 5
seconds, until the sunroof glass vibrates, and accompanied
with "clicking" sounds, release the switch, and complete
the sunroof initialization settings.
1
55