Emergency Brake Light Control System (Haz); Electronic Differential System (Xds) - MG 6 Manual

With the auto hold in the Parking state, it will result in
the electronic parking brake being applied and the system
exiting the Parking state in some cases (such as removing
the seat belt, switching off the engine and stopping for a
certain time etc.)
Note: For manual transmission models, please press
the accelerator pedal to start off when the auto hold
function is enabled.
Note: With the brake pressed, press the switch to
switch off the auto hold function, but the electronic
parking brake will not be applied.
Note: It is recommended to turn off the auto hold
function when reversing into the garage.
Emergency Brake Light Control System
(HAZ)
With the car driving at high speed (above 50km/h), when
the driver makes an emergency brake, the system will
automatically enable the brake lamp strobe to remind the
following vehicles, thereby effectively reducing the risk of
rear-end collision accidents.
198
Starting & Driving
Note: With the hazard warning lamp turned on, the
emergency brake light control system (HAZ) will not
function.
After HAZ is activated, when the car is not in emergency
brake condition (e.g. when the deceleration is small), the
brake lamp strobe function will stop after several seconds.
Note: If the car speed is less than 10km/h when the
brake lamp strobe stops, the hazard warning lamp
will illuminate automatically. Short press the hazard
warning lamp switch or speed up to above 20km/h for
5s to turn off the hazard warning lamp.

Electronic Differential System (XDS)

Your car is provided with electronic differential system
(XDS). In case the understeering occurs when making a
turn at high speed, the system will apply the brake to the
wheels at inner side to improve the accuracy of steering.