Ultrawave Qi Series Operator's Instruction Manual page 19

Screen 4: Cycle Count
The second screen shows the number of cycles which the Qi-Series ultrasonic
bath has run since new.
The cycle count shows all cycles which the bath has begun and includes those
cycles which are not completed; i.e. those cycles aborted by the operator or
because the fluid level was low.
Screen 5: Low power
In its factory pre-set mode, the Qi-Series ultrasonic bath will maintain the
set fluid temperature. This means that it is consuming power when sitting
idle (i.e. when the sonics are not running).
The Qi-Series can be set to save power when not in use.
Setting Low Power to ON means that after five minutes of inactivity, the Qi-
Series ultrasonic bath will enter its SLEEP mode – the screen illumination will
power down, and the internal water heater will not operate.
The Qi-Series ultrasonic bath uses less than 10Watts of power whilst in SLEEP
mode.
By setting Low Power to OFF, the Qi-Series screen will maintain the set fluid
temperature; i.e. when the fluid temperature falls below the specified setting,
the heaters will automatically switch on, meaning the bath is immediately
ready for use when required.
When the desired option is selected, use the MENU key to move to the next
screen.
Qi Operating Manual 19 C6027205