Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Ultrawave U50
Summary of Contents for Ultrawave U50
-
Page 3: Table Of Contents
Safety Instructions ..................... 1 Installation ....................... 3 Quick Guide ......................4 Manual I Control Panel Instructions (U50, U95, U100, U300) ..6 Manual II Control Panel Instructions (U100H) ........7 Manual III Control Panel Instructions (U300H, U500H) ....8 Technical Information ..................9 Ultrasonic cleaning detergents ..............10... -
Page 4: Safety Instructions
AWAY from the electrical connector and lead. The user should familiarise themselves with this Operator Instruction manual before operating the equipment and should apply to Ultrawave or its agent for advice on cleaning techniques and detergents. Ultrawave will not be responsible for damage or injury caused by incorrect use of the equipment. -
Page 5: Installation
Installation The following parts and accessories are included with the Ultra Analogue Benchtop ultrasonic baths: 1 x Ultra Analogue Benchtop ultrasonic bath 1 x basket 1 x lid 1 x 2m length of drain hose (U500H only) 1 x hose tail (U500H only) 1 x Ultraclean detergent sample 1 x Operator Instruction manual How to install... -
Page 6: Quick Guide
Change the cleaning liquid at regular intervals. Your cleaning process will determine how often to change the liquid – the more soiled your items, the more often you will need to change the liquid. Ultrawave recommend changing the cleaning liquid at least on a daily basis. - Page 7 REMEMBER Always ensure the liquid is at or above the lip of the tank when in operation. Do not put hot water above 50°C into the bath. Always use the basket to support items in the bath. Never expose hands, fingers or other body parts to cleaning solutions.
-
Page 8: Manual I Control Panel Instructions (U50, U95, U100, U300)
Manual I Control Panel Instructions (U50, U95, U100, U300) To switch on the ultrasonics: Turn the Timer dial to the desired time, and the press the SONICS button. The SONICS button and the SONICS light will glow. Ultrasonic activity will then commence in the liquid inside the tank and the Timer dial will be heard ticking. -
Page 9: Manual Ii Control Panel Instructions (U100H)
Manual II Control Panel Instructions (U100H) To switch on the ultrasonic activity: Turn the Timer dial to the desired time, and the ultrasonics will automatically begin. The SONICS light will glow. Ultrasonic activity will commence in the liquid inside the tank and the Timer dial will be heard ticking. -
Page 10: Manual Iii Control Panel Instructions (U300H, U500H)
Manual III Control Panel Instructions (U300H, U500H) To switch on the ultrasonic activity: Turn the Timer dial to the desired time, and the press the SONICS button. The SONICS button and the SONICS light will glow. Ultrasonic activity will then commence in the liquid inside the tank and the Timer dial will be heard ticking. -
Page 11: Technical Information
The time needed to degas the liquid varies depending on the amount of gas present in the liquid and the quantity of water in the tank. Ultrawave recommends a degas period of at least 10 minutes. -
Page 12: Ultrasonic Cleaning Detergents
Each of these detergents is available from Ultrawave. The required detergent dose may vary depending on the component being cleaned and the level of contamination. Ultrawave recommend a dosage of between 2 and 5% for all detergents other than Sonozyme. -
Page 13: Maintenance
Service or Investigation’, this can be found at www.mhra.gov.uk This policy is designed to protect the health and safety of Ultrawave employees reducing the risk of potential injury or infection If you require further information please contact the Service Dept. on:... - Page 14 Ultrawave. The user should familiarise themselves with this instruction booklet before operating the equipment and should apply to Ultrawave or its agent for advice on cleaning techniques or chemicals. Ultrawave will not be responsible for damage or injury caused by incorrect use.
-
Page 15: Troubleshooting
Troubleshooting Ultrawave have a dedicated service team who are able to resolve any problems that occur with your bath. However, on many occasions it is possible that the problem can be rectified by the operator. The unit fails to turn on... -
Page 16: Fuse Ratings
Ultrawave Service Department UK Mains Plug Fuse Ratings The following models must be fitted with a 5A fuse in the mains plug: U50, U95, U100, U100H, U300, U300H, U500H. Fitting fuses of the incorrect rating will invalidate the warranty. -
Page 17: Temperatures Of Touchable Hot Surfaces
(see below). Your Ultrawave ultrasonic bath can be set so that the cleaning fluid is up to 70°C. This means that parts of your ultrasonic bath will be above the recommended maximum temperature. -
Page 18: Compliance With The Control Of Noise At Work Regulations
To help you calculate your workers’ exposure, Ultrawave publish the noise generated by your ultrasonic cleaner on the Certificate of Test. The figure is that experienced by a worker standing in the operating position.
Need help?
Do you have a question about the U50 and is the answer not in the manual?
Questions and answers