Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ultrawave U Series
Summary of Contents for Ultrawave U Series
- Page 1 U Series Operator Instruction Manual C6000910-01 issued October 2021...
-
Page 2: Table Of Contents
Ultrasonic cleaning detergents ................. 13 Specifications ...................... 14 Maintenance ......................15 Troubleshooting ....................15 Returning equipment to Ultrawave ..............16 Warranty ....................... 17 WEEE Compliance ....................17 Compliance with the Control of Noise at Work regulations ......18 U-Series Operating Manual... -
Page 3: Safety Instructions
It can be dangerous to operate an ultrasonic bath without an earth connected. The U Series machines are rated at up to 850W maximum. The detachable mains lead is rated at 250V 6A. NEVER FIT A LEAD WITH A LOWER RATING. - Page 4 Ultrawave will not be responsible for damage or injury caused by incorrect use of the equipment. The user should apply to Ultrawave or its agent for advice on cleaning techniques or detergents. IMPORTANT: Once the cleaning cycle has finished, remove the cleaned items, and rinse them immediately in clean running water.
- Page 5 Safety Symbols Danger Indicates an imminently hazardous situation which will result in serious or fatal injury. This symbol is used only in the most extreme conditions. Caution Indicates a potentially hazardous situation which may result in minor or moderate injury. It may also be used to alert against unsafe practices.
-
Page 6: Installation - U100, U100H, U300 & U300H
Installation – U100, U100H, U300 & U300H The following parts and accessories are included with the U-Series ultrasonic baths: 1 x U-Series ultrasonic bath 1 x basket 1 x lid 1 x Ultraclean detergent sample 1 x Operator Instruction manual How to install. -
Page 7: Installation - U500H, U1300H & U2500H
Installation – U500H, U1300H & U2500H The following parts and accessories are included with the U-Series ultrasonic baths: 1 x U-Series ultrasonic bath 1 x basket 1 x lid 1 x 2m length of drain hose 1 x hose tail 1 x Ultraclean detergent sample 1 x Operator Instruction manual How to install... -
Page 8: Quick Guide
Change the cleaning liquid at regular intervals. Your cleaning process will determine how often to change the liquid – the more soiled your items, the more often you will need to change the liquid. Ultrawave recommends changing the cleaning liquid at least on a daily basis. U-Series Operating Manual C6000610... -
Page 9: Manual I Control Panel Instructions (U100, U300)
Manual I Control Panel Instructions (U100, U300) To switch on the ultrasonics: Turn the Timer dial to the desired time, and then press the SONICS button. The SONICS button and the SONICS light will glow. Ultrasonic activity will then commence in the liquid inside the tank and the Timer dial will be heard ticking. -
Page 10: Manual Ii Control Panel Instructions (U100H)
Manual II Control Panel Instructions (U100H) To switch on the ultrasonics: Turn the Timer dial to the desired time, and the ultrasonics will automatically begin. The SONICS light will glow. Ultrasonic activity will commence in the liquid inside the tank and the Timer dial will be heard ticking. -
Page 11: Manual Iii Control Panel Instructions (U300H, U500H, U1300H & U2500H)
Manual III Control Panel Instructions (U300H, U500H, U1300H & U2500H) To switch on the ultrasonics: Turn the Timer dial to the desired time, and the press the SONICS button. The SONICS button and the SONICS light will glow. Ultrasonic activity will then commence in the liquid inside the tank and the Timer dial will be heard ticking. -
Page 12: Technical Information
The time needed to degas the liquid varies depending on the amount of gas present in the liquid and the quantity of water in the tank. Ultrawave recommends a degas period of at least 10 minutes. -
Page 13: Ultrasonic Cleaning Detergents
Ultrawave offers a range of specially formulated ultrasonic detergents for use in applications including medical and heavier industrial cleaning requirements. -
Page 14: Specifications
Specifications Ambient Temperature 5 to 40°C 80% R.H. in room temperatures up to Maximum relative humidity 31°C decreasing linearly to 50 % R.H. at 40°C Altitude above sea level Up to 2,000 m (6,500 ft) Operating Environment Indoor use only Electrical details Mains supply: 230V @ 50Hz... -
Page 15: Maintenance
Ultrawave. Troubleshooting Ultrawave has a dedicated After Sales team who are able to resolve any problems that occur with your bath. However, on many occasions it is possible that the problem can be rectified by the operator. -
Page 16: Returning Equipment To Ultrawave
Ultrawave. Where appropriate, we operate a Return to Base (RTB) warranty and repairs policy. Returning equipment to Ultrawave All equipment being returned to Ultrawave for service, repair or other reason MUST BE FULLY DECONTAMINATED prior to return and include a copy of the certificate of decontamination. -
Page 17: Warranty
Ultrawave. The user should familiarise themselves with this instruction booklet before operating the equipment and should apply to Ultrawave or its agent for advice on cleaning techniques or chemicals. Ultrawave will not be responsible for damage or injury caused by incorrect use. -
Page 18: Compliance With The Control Of Noise At Work Regulations
To help you calculate your workers’ exposure, Ultrawave publish the noise generated by your ultrasonic cleaner on the Certificate of Test. The figure is that experienced by a worker standing in the operating position. - Page 20 Ultrawave Ltd Eastgate Business Park Wentloog Avenue Cardiff CF3 2EY www.ultrawave.co.uk Tel +44 (0) 29 2083 7337 C6000910-01 issued October 2021...
Need help?
Do you have a question about the U Series and is the answer not in the manual?
Questions and answers