Table of Contents
Advertisement
12. Daily Maintenance and Handling
Regularly check the probe for material accumulation or damage and clean as
needed. Replace the device if it is damaged.
Before removing and reinstalling the device, carefully clean the probe neck and
the mounting slot, especially the sealing cone. Take appropriate methods to
ensure that no external matter enters the device.
Attention! If the medium is changed, you need to change the sensor model or
adjust the sensitivity (driver and software required).
The sensor is packaged on a one-time basis and cannot be repaired.
Follow local regulations when disposing of the device.
Before returning the product, make sure that the product is free of dirt, especially
dangerous or toxic substances. Appropriate packaging must be used to avoid damage
to the device.
12.1 Euipment cleaning for dust-explosion zone
When cleaning the non-metallic surface of the equipment, wipe only with a damp
cloth that has been wrung out well.
When cleaning the non-metallic surface of the M12 cable connection, wipe only
with a damp cloth that has been wrung out well.
21
Advertisement
Table of Contents
