Grounding Instructions For Dust-Explosion Zone - FineTek SIS Operation Manual

Rear install type
Top-mounted
High/low alarm and to
solve the problem that
no hole in

After installation, please check whether the resistance of the container or
pipe entrance is within the allowable range.

Make sure that the top cable is properly sealed, such as installing and locking
the cable gland.

Cables cannot be routed directly upwards, please go around for a short
distance and then route them upwards to release water.

10.4 Grounding instructions for dust-explosion zone


To prevent dust or flow being generated by friction or impact, this product can
be used in the dust-explosion area. Please confirm the grounding condition in
the installation environment and take proper grounding.

If the connection is the metal tank or pipe, this product is grounded through
"thread adapter" and metal tank or pipe. Please confirm that the installation
environment is grounded to prevent electrostatic charge.

If the connection is not the metal tank or pipe, the sensor must be installed
with the exclusive "Thread adapter" and use "thread adapter" to complete the
grounding.
the side.
Side-mounted
The probe crosses the material of
the barrel wall and effectively
inhibits bridging.
18