Wiring Instructions - FineTek SIS Operation Manual

11. Wiring Instructions

Attention! Wiring must be carried out by an electrician.
Make sure you comply with national and international regulations related to
the installation of electrical equipment.
The input power supply must be within the specifications of the product.

Turn off the power before wiring.

Make connections according to the wiring diagram below.

Insert the connector plug into the top socket of the sensor and tighten the nut.
Wiring diagram:

R1 and R2 represent the load of OUT1 and OUT2 respectively.

To protect the sensor from damage in the event of system failure, adding FUSE
0.5A to the power circuit is recommended.

only represents the property. The actual wire color depends on the connector
purchased.
Note: The accuracy and efficiency can not be guaranteed if using NON-FineTek
connector.
19